Home
Cart

Cart

Get an offer

Full name*

E-Mail*

telephone*

Company*

street*

place*

zip code*

country*

additional information

I agree that my details and data are collected and stored electronically in order to answer my enquiry.

Your cart

9 article(s) in your cart
pos.	image	product	Configure	Actions
1		QFS-55
2		DS-CAN-01
3		ER-214
4		T203.F
5		ViscoScope® VA-300
6		BK-390
7		ZDT-Serie
8		ZMF-203e-IR
9		T204.F

QFS-55 configure

1 Ausführung

2 Kontakt

3 Schaltkontakt

4 Kabelmaterial

5 Kabellänge

6 Ex-Option

Amount

additional infomation

ER-214 configure

1 Gehäuse

2 Ausgang

3 Schaltverzögerung

4 Empfindlichkeitsbereich

5 Versorgungsspannung

6 Quittiertaster

Amount

additional infomation

ViscoScope® VA-300 configure

1 Viscosity

2 Temperature

3 Process-Connection

4 Material

5 Non-active-Extension

6 Ex-Bereich

Amount

additional infomation

BK-390 configure

1 Rohr-Außendurchmesser

2 Kontakt

3 Stecker

Amount

additional infomation

ZMF-203e-IR configure

1 Typ

2 Temperaturbereich

3 Messmethode

4 Signalausgang

5 Messbereich

6 Ex-Zulassung

Amount

additional infomation

QFS-55

Teflon float switch in rod design

The float switch combination is built with float switches of the QFS-50 and QFS-60 series. This makes it possible to control a level in a simple way.

Technical Data

Material : PTFE (Teflon)
connection cable : Silikon, Teflon
Material rod : VA-Rohr, PTFE beschichtet
Operating temperature : max. +150 °C
media density : ρ ≥ 0,75 g/cm³
Switching system : Reed-Schalter
Contact : Wechsler, NO, NC
Inductive/capacitive loads : Unbedingt Kontaktschutz vorsehen
Ex-protection optional : Elektrische Daten siehe EG-Prüfbescheinigung IBExU10ATEX 1089

Reed contact

Switching current : 1 mA ... 1 A
Switching voltage : 24 ... 250 V AC/DC
Switching capacity : Max. 1A, 60 VA / 60 W
Switching hysteresis : ca. 100 mm
Switching angle : ca. +20°...–20°

Namur circuit (1kΩ/12kQ)

Switching current / switching voltage : nur zum Anschluss an KR-163... oder andere „Namur”-Relais
Switching hysteresis : ca. 100 mm
Switching angle : ca. +20°...–20°

DS-CAN-01

CANopen pressure transmitter with CAN bus signal output

Versatile, media-compatible pressure transmitter with CAN bus interface.

technical properties

Pressure type : Relativdruck gegen Umgebungsdruck bzw. gegen interne Atmosphäre
measuring resolution : 10 Bit
Measuring accuracy : Klasse 0,5 bei RT
Total error : < 1,5 % v.E bei -10 °C … +80 °C.
measuring grid : ab 5 ms
CAN protocol : CANopen 2.0 A
Physical Layer : nach DIN 11898

ambient conditions

Operating temperature range : -40 °C … +80 °C
Storage temperature range : -40 °C … +120 °C
Shock resistance : 30 g, Dauer
Vibration resistance : 10 g bei 20-1000 Hz
EMC/ESD : EN 50082-1 und EN 50082-2
Duration : 14 ms bei RT

Pressure measuring ranges

kPa : bar
0...500 : 0…5
0...1.000 : 0…10
0...2.000 : 0…20
0...5.000 : 0…50
0...10.000 : 0…100
0...35.000 : 0…350
0...50.000 : 0…500
0...70.000 : 0…700
0...200.000 : 0…2.000
0...400.000 : 0…4.000
Standard pressure range : in kPa
Non-standard ranges : auf Anfrage erhältlich

ER-214

Electrode Relays

Electrode relays for conductive level detection for all areas in which conductive, liquid media are to be detected, controlled or monitored

Properties

Protection class EN60529 clamp : IP 20
Protection class EN60529 front panel housing : IP 40
Operating temperature : –20...+60 °C
Storage temperature : –30...+80 °C
AC nominal frequency : 48...62 Hz
Power consumption : max. 1 W / VA
Weight : ca. 150 g

Input

Open circuit voltage : ≤ 10 V AC
Short-circuit current : ≤ 5 mA

Output

Contacts : 1 potentialfreie Wechselkontakte pro Kanal
Switching voltage : min. 5 V | max. 250 V AC | max. 150 V DC
Switching current : min. 5 mA | max. cosφ=1 3A | max. cosφ=0,7 1 A/AC | max. cosφ=1
Switching capacity : min. 300 mW | max. 750 VA / 150 W (30 V DC / 5 A) / 18 W (150 V DC / 0,12 A)
Working / Idle current : umschaltbar
overvoltage category : EN 61010-1 Kategorie III

T203.F

Overfill protection for containers

Level sensors type T-20_.F... are approved by the DIBt (German Institute for Structural Engineering) as liquid level limit switches for the overcharge protection of containers for storing water-dangerous liquids.

Properties

Protection class : IP 65 Dose
Sliding tube length : max. 6000 mm
Operating temperature : max. 135 °C
Operating pressure : max. 20 bar
F-Contact : 1/12 kΩ
Switching current : 1A, 2A
Switching voltage : 230 V AC

Float

quantity : max. 6
Type 05 : Oval Edelstahl 76 mm Ø | Dichte 0,81 g/cm³
Type 06 : Oval Edelstahl 90 mm Ø | Dichte 0,67 g/cm³
Minimum contact distance : Typ 05: 110 mm | Typ 06: 135 mm

Switching contacts and switching capacity

Changeover contact : max. 5x | 60 W/VA
normally open : max. 6x | 100 W/VA
Normally closed contact : max. 4x | 60 W/VA

ViscoScope® VA-300

Maintenance-free inline process viscometer for real-time viscosity measurement

The ViscoScope® sensors are made of high-quality, first-class stainless steel and impress with their intelligent, robust design.

Properties

Protection class : IP65
Material : 1.4571 / 1.4404 (316Ti / 316L)
Process temperature : -40°C … +450°C
Process pressure : Vakuum ... 450 bar
Process connections : DIN Flansch | ANSI Flansch | NPT | Varivent® | Tri-Clamp
Cable length sensor - transmitter : max. 1.000m
max. flow velocity : 10 m / sec
Ex approval : (optional) II 1/2G Ex ia IIC T6...T3 Ga/Gb
Material (optional) : Hastelloy C22, Duplex 2205, Teflon

Sensor types

big cylinder : VA-300L
small cylinder : VA-300M
Sphere : VA-300H
small sphere : VA-300X

Measuring range

VA-300L : 0,1 - 2.500 mPa·s x g/cm³
VA-300M : 1 - 25.000 mPa·s x g/cm³
VA-300H : 0,01...250 Pa·s x g/cm³
VA-300X : 0,1...2.500 Pa·s x g/cm³

Probe dimensions

VA-300L : Ø 32 x 190 mm
VA-300M : Ø 32 x 165 mm
VA-300H : Ø 32 x 130 mm
VA-300X : Ø 19 x 115 mm

BK-390

Bistable change-over contact

Magnetically actuated changeover switch, which permanently changes its electrical switching state as a result of a magnetic system passing by, depending on the direction of movement.

Properties