Home
Cart

Cart

product added to request

Get an offer

Full name*

E-Mail*

telephone*

Company*

street*

place*

zip code*

country*

additional information

I agree that my details and data are collected and stored electronically in order to answer my enquiry.

Your cart

9 article(s) in your cart
pos.	image	product	Configure	Actions
1		EFV2 24V
2		QFS-12
3		LGW-13
4		TK-101 EX
5		T-200.L
6		QFSK-2X
7		ZDT-H
8		cIO CANopen Module
9		T204

EFV2 24V configure

1 Sicherheitsfunktion

2 Verstellbar

3 Elektrodenanzahl

4 Verschraubungsmaterial

5 Stabmaterial

6 Anschluss

7 Anschlussgewinde

8 Kabelbruchwiderstand

9 Auswerteelektronik

10 Standaufnehmerlänge

11 SIL

Amount

additional infomation

QFS-12 configure

1 Kontakt

2 Schwimmermaterial

3 Kabelmaterial

4 Kabellänge

Amount

additional infomation

TK-101 EX configure

1 ATEX

Amount

additional infomation

T-200.L configure

1 Länge

2 Anschluss

3 Anschlussgewinde

4 Befestigungswinkel

5 Schwimmertyp

Amount

additional infomation

QFSK-2X configure

1 Schwimmertyp

2 Anschlussgewinde

3 Schwimmeranzahl

4 Stablänge

5 EX

Amount

additional infomation

EFV2 24V

adaptive conductive electrodes with and without 24 V direct connection

The conductive electrode EFV2 is approved by the "DIBt" as an overfill prevention device for liquids hazardous to water.

Connection

Box : Polyesterdose (PO)
Cable : Kabel (TPK)
Plug : Stecker (ST)

Properties

Protection class : IP 65
connection thread : G2"
Union nut : G2¾", S 100x8
Material Screw connection : PE, PVC, PPH, PVDF
Material Sensor rods : Edelstahl (1.4571), Hastelloy C, Titan, Tantal, Kohlestifte
Operating temperature : PE, PVC: atmosphärisch PPH : 90 °C, PVDF: 100 °C
Operating pressure : atmosphärisch
Resistance value of line monitoring : 22 kΩ / 100 kΩ je nach Ausführung

Operating temperature

PE : atmosphärisch
PVC : atmosphärisch
PPH : 90 °C
PVDF : 100 °C

Technical specifications electronic part

Operating temperature : –20...+85 °C
Storage temperature : –30...+85 °C
nominal voltage : 24...30 V DC
Power consumption : max. 2 W
Switching voltage : max. 230 V AC / V DC min. 5 V DC (CMOS-Relais)
Switching current : max. 0,12 A AC / A DC min. <1 mA
Switching capacity : max. 25 VA / W
Sensitivity : 3k … 100 kΩ

QFS-12

Two-Point Float-Switch

With the two-point float switch Type QFS-12 can be realized pump controls in liquid media on a simple way.

Properties

Protection class EN60529 : IP68
Side installation : PVC-Stopfbuchsverschraubung G 2”
Installation from above : PVC-Stopfbuchsverschraubung G 2”
Operating pressure : max. 2 bar
Contact : Wechselkontakt
Switching voltage : 4....250 V AC / DC
Switching current : 1mA.....1A
Switching capacity : 60W/VA
media density : ρ ≥ 0,9 g/cm³ bis ρ ≥ 0,8 g/cm³
Material Float : Polyethylen

Cable

TPK : PVC Basis
TPKV : PVC Basis verstärkt
PUR : Polyurethan
NEO : Neopren
SIL : Silikon
FEP : Teflon
AEM : Ethylen-Acrylat-Kautschuk

Operating temperature

TPK(V), NEO, AEM : max.+60 °C
PUR : max.+70 °C
FEP, SIL : max.+80 °C

LGW-13

CO2 sensor for measuring room air quality with visual and acoustic warning signal output

Multifunctional CO2 sensor with LED display and acoustic alarm, equipped with switching functions for both industrial and private applications (0...3.000ppm)

Product features

Product type : CO2-Sensor zur Bewertung und Überwachung der Luftgüte
Measuring principle : Basierend auf optischem Messprinzip (NDIR)
Measuring range : Lieferbar in unterschiedlichen Messbereichen (Standard 0…3.000ppm)
Display : Darstellung der CO2-Konzentration mittels Bargraphanzeige (Luftgüteampel)
Switching output : Einstellbarer potentialfreier Schaltausgang
Signal output : 4...20 mA und 0...10 V Signalausgang (nur bei der Variante L)
Alarm : Akustischer Alarmmelder (je nach eingestellten CO2-Grenzwerten)
further function : Integrierte Funktionsüberwachung
Housing : Kompaktes IP 20 Wandgehäuse (Polycarbonat, weiß)
Extension : Mögliche Erweiterung um Temperaturmessung
Assembly : Erhältlich als Tischgerät mit Netzteil oder zur Wand- & Aufputzmontage ohne Netzteil

Technical specifications

Standard measuring range: : 0…3.000ppm
Optional measuring ranges: : 0…1% vol, 0…3% vol (weitere auf Anfrage)
Accuracy : +-3% vom Messbereich (30 ppm bei 3.000 ppm)
Relay output: : Potentialfrei
Response time : ca. 20 s
Operating voltage : 24 V DC, 150 mA

TK-101 EX

Measuring transducer (R/I-transducer)

The measuring transducer Tk101 and Tk101Ex are built directly into the connection boxes of our Liquid Level Measuring Instruments of type TK-30.

Properties

Operating temperature : -20...+60 °C
Storage temperature : -40...+80 °C
Ex-protection : siehe Zertifikat
CE marking : siehe Konformitätserklärung

Input

Resistance range in three-wire circuit : 4...10 kΩ
Measuring current : 0,8 mA @ RE = 4 kΩ
Measuring current : 0,33 mA bei RE = 10 kΩ
Measuring voltage : 3,3 V

Supply/Output

2-wire : 4...20 mA
Voltage(Um) : 11...28 V DC
Burden / load : 0...800 Ω |RBürde max = [(Um - Um min) / 0,02] Ω
Output signal in case of error : max. 24 mA

Fault influences

Max. Total error : ± 1 %
Temperature influence : -0,015 % / °C
Supply voltage influence : 0,025 % / V

Setting range

Full deflection : 60...105 %
Zero point adjustment : 0...25 %

T-200.L

Leakage probes with general building authority approval

The leakage probes T-200.L are approved by the "DIBt" on the basis of the "WasBauPVO" for the detection of leaked liquids hazardous to water.

Connection

Box : Polyesterdose (PO)
Box : Polyethylen-Anschlusskopf (PE)
Cable : Kabel (TPK)
Plug : Stecker (ST)

Properties

Protection class : IP 65
Cable entry : PVDF-Verschraubung , PVC-Dichtung
Material Float : PE
Material leakage probe base : PE
Cable : TPK (PVC Basis)
Operating temperature : atmosphärisch
Operating pressure : atmosphärisch
media density : mit Schwimmer PE 52 ρ ≥ 1,05 g/cm³
Switching hysteresis : typ. 2 mm
Switching point tolerance : max. 2 mm

Resistance value

Operational readiness : ca. 1 kΩ
Leakage detection : ca. 12 kΩ

QFSK-2X

Stainless steel float switch combination

Float switch combinations QFSK for level monitoring & level control with maximum and minimum contact sensor.

Properties

Protection class EN60529 : IP 68
Material Float : VA 1.4571
Material hose : Edelstahlwellschlauch (1.4404) mit Edelstahldrahtumflechtung (1.4301)
rod length : max. 5 m
Number of floats : bis 5
Operating temperature : max. + 150 °C
media density : ρ ≥ 0,8g/cm³
Switching system : Reed-Schalter
Contact : Wechsler, NO, NC
Switching voltage : 4...250 V AC/DC
Switching current : 1 mA ...1 A
Switching capacity : max. 1A, 60 VA/60 W
Switching hysteresis : ca. 100 mm
Switching angle : ca. + 20° / – 20°
Ex-protection : optional; IBExU10ATEX 1089
Operating pressure WFSK-25 : max. 15 bar
Operating pressure QFSK-26 : max. 6 bar

ZDT-H

Differential pressure transmitter for high pressure applications

Versatile and reliable differential pressure transmitter for measuring air, non-aggressive media as well as liquids and oils.

Properties

Pressure type : Differenzdruck
Housing : Kunststoff mit LCD-Anzeige (oponal)
Overpressure : 1,2* (1,5*) x Nenndruck

Measurement parameters

Total error : ± 2,5 % FS (typ. ± 0,5 %)
Linearity error : ± 1 % FS
Signal output selection : 0...10 V 4...20 mA, 2-Leiter 4...20 mA, 3-Leiter
Pressure range : 5…1.000 bar

Operating conditions

Operating voltage : 14...28 VDC ± 10 %
Operating temperature : 0...+50 °C
Storage temperature : -20°C...+120°C

Connections

Electrical connection : Schraubklemme im Gehäuse
Process connection : G1/4" (andere auf Anfrage)

cIO CANopen Module

Compact I/O modules for DIN rail mounting

product series of compact CANopen I/O modules with various electrical connections

Properties

Housing : Kunststoffgehäuse zum Aufrasten auf DIN-Trageschienen
Dimensions : ca. (LxBxH) 18 x 90 x 62 mm
Internal circuits : Ausgangsschutzschaltungen gegen Überspannung und elektrostasche Entladung
Fieldbus and I/O level : getrennt durch galvanische Trennung

ElectricalConnection

Operating voltage : 11...32V DC (typ. 24V DC)
Operating temperature : 0...+55 °C
Operating temperature : optional -40...+70 °C
Conductor cross-section : 0,08...1,5 mm² (AWG28...AWG14)

CAN bus properties

baud rate (max.) : 1 MBit
ciA Standards : Ds301 Version 4.2 & DS401 Version 3.0
ISO standards : ISO11898 (+ Transceiver TJA1050)
PDO : siehe Dokumente

T204

Magnetic immersion probe made of stainless steel (1.4571)

For use with highly aggressive liquid media to detect level limit values in containers. Suitable for use in hazardous areas, zone 0 (category 1).

Properties

connection : Polyesterdose | Aluminiumdose
Protection class EN60529 : IP 65 Anschlussdose
connection thread : G1 1/2" | G2"
Sliding tube length : max. 6000 mm (Rohr Ø 12 mm)
Operating pressure : max. 20 bar (Kugel) | max. 15 bar (Zylinder)
Operating temperature : max. 135 °C
Number of floats : max. 4

Float type

Stainless steel ball 52mm ⌀ : Dichte: 0,75 g/cm³ | mind. Kontaktabstand: 75 mm
Stainless steel ball 62mm ⌀ : Dichte: 0,65 g/cm³ | mind. Kontaktabstand: 85 mm
Stainless steel cylinder 44 mm Ø : Dichte: 0,76 g/cm³ | mind. Kontaktabstand: 75 mm

Switching capacity