Home
Cart

Cart

product added to request

Get an offer

Full name*

E-Mail*

telephone*

Company*

street*

place*

zip code*

country*

additional information

I agree that my details and data are collected and stored electronically in order to answer my enquiry.

Your cart

8 article(s) in your cart
pos.	image	product	Configure	Actions
1		T205-0.F
2		TK-101 EX
3		TSL-CAN-03
4		T200.F-24V
5		LGW-13
6		XR Relais
7		ZDS-Serie
8		QFS-40

TK-101 EX configure

1 ATEX

Amount

additional infomation

T200.F-24V configure

1 Führungsrohr

2 Sicherheitsfunktion

3 Rohrmaterial

4 Anschlussgewinde

5 Ausführung

6 Schwimmermaterial

7 Anschluss-Elektronikteil

Amount

additional infomation

QFS-40 configure

1 Anschluss

2 Gehäusematerial

3 Kabelmaterial

4 Kabellänge

Amount

additional infomation

T205-0.F

Ex area zone 0 (category 1)

The magnetic immersion probes T20... are used to detect fill level limit values in containers for liquid media, where an explosive atmosphere of zone 0 (cat. 1) is present in the gas space above the liquid and Ex zone 1 (cat. 2) is present outside the container, in the area of the junction box.

Properties

Protection class : IP 68 Kabel
connection cable : max. 10 Meter PUR
Sliding tube length : Max. 6000 mm
Operating temperature : max. 120 °C
F-Contact : 1 / 12 kΩ

Float

Stainless steel ball 44 mm Ø : max. 15 bar | 0,60 g/cm³
Stainless steel cylinder 27 mm Ø : max. 10 bar | 0,78 g/cm³

TK-101 EX

Measuring transducer (R/I-transducer)

The measuring transducer Tk101 and Tk101Ex are built directly into the connection boxes of our Liquid Level Measuring Instruments of type TK-30.

Properties

Operating temperature : -20...+60 °C
Storage temperature : -40...+80 °C
Ex-protection : siehe Zertifikat
CE marking : siehe Konformitätserklärung

Input

Resistance range in three-wire circuit : 4...10 kΩ
Measuring current : 0,8 mA @ RE = 4 kΩ
Measuring current : 0,33 mA bei RE = 10 kΩ
Measuring voltage : 3,3 V

Supply/Output

2-wire : 4...20 mA
Voltage(Um) : 11...28 V DC
Burden / load : 0...800 Ω |RBürde max = [(Um - Um min) / 0,02] Ω
Output signal in case of error : max. 24 mA

Fault influences

Max. Total error : ± 1 %
Temperature influence : -0,015 % / °C
Supply voltage influence : 0,025 % / V

Setting range

Full deflection : 60...105 %
Zero point adjustment : 0...25 %

TSL-CAN-03

Temperature sensor with CAN bus interface for air temperature measurement

CANopen transmitter for temperature measurement in media, semiconductor sensor

Properties

Measuring range : -40…+80 °C
deviation : ± 0,3 K (10...80 °C)
Measuring element : Halbleiter-Diodenfühler
measuring resolution : 0,1 K
measuring grid : ab 5 ms

ElectricalConnection

CAN protocol : CANopen 2.0 A, nach ciA DS 404
Physical Layer : nach DIN 11898
Operating voltage : 10...48 V

Operating conditions

Operating temperature : -40...+80 °C
Storage temperature : -40°C...+120°C
Shock resistance : 30g, Dauer: 14 ms bei Raumtemperatur
Vibration resistance : 10g bei 20 bis 1000 Hz
Minimumairspeedrequiredformeasurementacrossthesensor : 1,5 m/s

T200.F-24V

Overfill protection with 24V direct connection

Level sensors type T-20_.F... are approved by the DIBt (German Institute for Structural Engineering) as liquid level limit switches for the overcharge protection of containers for storing water-dangerous liquids.

Connection

ltdata.Polyesterdose : PO/ET-520
ltdata.Polyethylenanschlusskopf : PE/ET-521

Properties

Protection class EN60529 : IP 65
connection thread : G 1", G 1¼", G 1½", G2", G3”
Union nut : G 2¾", S 100x8
Guide tube length : max. 6 m
Operating temperature : max. 80 °C
Operating pressure : atmosphärisch
media density : ρ ≥ 0,6 g/cm³ (je nach Schwimmertyp)
Switching hysteresis : typ. 2 mm
Switching point tolerance : max. 2 mm

Power supply

nominal voltage : 24 V DC (24…300V DC)
Power consumption : ≤ 1 W

Output

Output contact : 1 potentialfreier Wechselkontakt
Switching voltage : max. 250 V AC / 30 V DC
Switching current : max. 3 A AC / 3 A DC
Switching capacity : max. 750 VA / 90 W

Optocoupler

Switching voltage : max. 30 V
Switching current : max. 100 mA
displays : Betriebs-LED grün, Funktions-LED rot
Switching delay : ca. 0,5 s Anzug/Abfall

LGW-13

CO2 sensor for measuring room air quality with visual and acoustic warning signal output

Multifunctional CO2 sensor with LED display and acoustic alarm, equipped with switching functions for both industrial and private applications (0...3.000ppm)

Product features

Product type : CO2-Sensor zur Bewertung und Überwachung der Luftgüte
Measuring principle : Basierend auf optischem Messprinzip (NDIR)
Measuring range : Lieferbar in unterschiedlichen Messbereichen (Standard 0…3.000ppm)
Display : Darstellung der CO2-Konzentration mittels Bargraphanzeige (Luftgüteampel)
Switching output : Einstellbarer potentialfreier Schaltausgang
Signal output : 4...20 mA und 0...10 V Signalausgang (nur bei der Variante L)
Alarm : Akustischer Alarmmelder (je nach eingestellten CO2-Grenzwerten)
further function : Integrierte Funktionsüberwachung
Housing : Kompaktes IP 20 Wandgehäuse (Polycarbonat, weiß)
Extension : Mögliche Erweiterung um Temperaturmessung
Assembly : Erhältlich als Tischgerät mit Netzteil oder zur Wand- & Aufputzmontage ohne Netzteil

Technical specifications

Standard measuring range: : 0…3.000ppm
Optional measuring ranges: : 0…1% vol, 0…3% vol (weitere auf Anfrage)
Accuracy : +-3% vom Messbereich (30 ppm bei 3.000 ppm)
Relay output: : Potentialfrei
Response time : ca. 20 s
Operating voltage : 24 V DC, 150 mA

XR Relais

Electrode relays and contact protection relays

The electrode relays are used for conductive level detection. levels. The possible applications extend areas where conductive, liquid media are to be detected, controlled to be detected, controlled or regulated. Hereby level detection (overflow / dry run) as well as minimum / maximum as well as minimum / maximum controls can be realised. The contact protection relays are universal measuring transducers, which input signals (resistance values) with "Namur" specification (DIN EN 60947). Namur" specification (DIN EN 60947) into switching signals of floating output contacts.

Protection class EN60529