Home
Cart

Cart

product added to request

Get an offer

Full name*

E-Mail*

telephone*

Company*

street*

place*

zip code*

country*

additional information

I agree that my details and data are collected and stored electronically in order to answer my enquiry.

Your cart

12 article(s) in your cart
pos.	image	product	Configure	Actions
1		T-200.F Ex
2		XR-4x2
3		Aero_aH100
4		LU-1X0
5		TK-101 EX
6		ZS-Serie
7		ZDT-Serie
8		ER-107
9		T203.F
10		NSP-X-E
11		T200
12		ZCS-5000

T-200.F Ex configure

1 Führungsrohr

2 Sicherheitsfunktion

3 Rohrmaterial

4 Anschlussgewinde

5 Ausführung

6 Schaltkontakte

7 Schwimmermaterial

8 Anschlussdose

9 Länge

10 EX

Amount

additional infomation

XR-4x2 configure

1 Kanalanzahl

2 WHG

3 Gehäuse

4 Ausgang

5 Schaltverzögerung

6 Empfindlichkeitsbereich

7 Versorgungsspannung

8 Busanschluss

9 SIL

10 ATEX

Amount

additional infomation

LU-1X0 configure

1 Typ

Amount

additional infomation

TK-101 EX configure

1 ATEX

Amount

additional infomation

NSP-X-E configure

1 Messbereiche

2 Gabeloberfläche

Amount

additional infomation

T-200.F Ex

Overfill protection for containers with Ex approval

Level sensors type T-20_.F... are approved by the DIBt (German Institute for Structural Engineering) as liquid level limit switches for the overcharge protection of containers for storing water-dangerous liquids.

Connection

Box : Ex-Polyester
Box : Ex-Aluminium

Properties

Protection class EN60529 : IP 65
connection thread : G2"
Union nut : G 2¾"
Guide tube length : max. 6 m
Operating temperature : -20…+60 °C
Operating pressure : max. 6 bar je nach Ausführung
media density : ρ ≥ 0,72 g/cm³ (je nach Schwimmertyp)
Switching hysteresis : 2 mm
Switching point tolerance : max. 2 mm

Resistance value

Operational readiness : ca. 1 kΩ
overfill alarm : ca. 12 kΩ
Switching time : ca. 20 ms
Ex-protection : siehe Baumusterprüfbescheinigung
CE marking : siehe Konformitätserklärung

XR-4x2

Electrode relay with ATEX and WHG approval

The electrode relays are used for conductive level detection. levels. The possible applications extend areas where conductive, liquid media are to be detected, controlled to be detected, controlled or regulated. Hereby level detection (overflow / dry run) as well as minimum / maximum as well as minimum / maximum controls can be realised.

Protection class EN60529

clamp : IP20
Housing : IP40

Technical Data

Operating temperature : -20...+60 °C
Storage temperature : -30...+80 °C
Output contacts : potentialfrei
Switching voltage : min. 5 V, max. 250 V AC / 150 V DC
Switching current : min. 5 mA, max. 5 A AC / 5 A DC
Switching capacity : min. 300 mW, max.100 VA / max. 50 W
CE marking : siehe Konformitätserklärung
Ex-protection/IECEx : siehe Baumusterprüfbescheinigung
Weight : ca. 170 g

Aero_aH100

Exhaust air fan with integrated dehumidification control for automatic room dehumidification

Dehumidification control, including integrated indoor and outdoor climate sensor. Controlled dehumidification takes place by comparing the indoor and outdoor climate. To support room dehumidification, a ventilation fan can be directly connected and controlled via the Aero_aH 100.

Properties

Power supply : 230V~ 50Hz
power consumption : 8 W
Protection class : IPX4
flow rate : 78 m³/h bis zu 92 m³/h
color : verkehrsweiß, ähnlich RAL 9016
Material : Kunststoff
Noise level : 27 dB(A) / 32 dB(A)
Signal output : I²C

Measuring range

measuring range (Humidity) : 0…100% rF
Measuring accuracy (humidity) : ± 2%
measuring range (Temperature) : -40...+80°C
Measuring accuracy (temperature) : ± 0,2°C

LU-1X0

Compact Ultrasonic Level Sensor

The LU-150 is a short-range integrated ultrasonic level transmitter, intrinsically safe as Ex-version LU-180. This general purpose, 2 wire, 4 to 20 mA loop powered transmitter is ideal for liquids, slurries, and bulk materials in open or closed vessels to 5 m (16.4 ft).

Properties

Protection class EN60529 : IP 68
Power supply : 12...30 V DC / 0.1A Spitze
Power consumption : Max. 0,75 W (25 mA bei 24 V DC)
Output : 4...20 mA
Max. Load : 600 Ω bei 24 V DC
Measuring span : Proportional oder umgekehrt proportional
Measurable materials : Flüssigkeiten, Schlämme, Schuttgüter
operating temperature : –20...+60 °C
Opening angle : 12°
working pressure : Atmosphärisch
Display : 3-stelliges LCD
Process connection : Gewinde G 2" (BSPP) EN 10226 PVDF
Weight : 1,3 Kg
Cable entry : Kabelverschraubung M 20 x 1.5
Material housing electronics : Polybutylenterephthalat PBT
Material sensor / thread : PVDF-Copolymer

Input

Measuring range : 0,25...5,0 m
frequency : 54 kHz

Measuring Accuracy

Measurement deviation : ± 0,25 % vom Messbereich (in Luft)
Resolution : 3 mm
Temperature compensation : im Sensor integriert
Echo processing : „Sonic Intelligence“ von Siemens

TK-101 EX

Measuring transducer (R/I-transducer)

The measuring transducer Tk101 and Tk101Ex are built directly into the connection boxes of our Liquid Level Measuring Instruments of type TK-30.

Properties

Operating temperature : -20...+60 °C
Storage temperature : -40...+80 °C
Ex-protection : siehe Zertifikat
CE marking : siehe Konformitätserklärung

Input

Resistance range in three-wire circuit : 4...10 kΩ
Measuring current : 0,8 mA @ RE = 4 kΩ
Measuring current : 0,33 mA bei RE = 10 kΩ
Measuring voltage : 3,3 V

Supply/Output

2-wire : 4...20 mA
Voltage(Um) : 11...28 V DC
Burden / load : 0...800 Ω |RBürde max = [(Um - Um min) / 0,02] Ω
Output signal in case of error : max. 24 mA

Fault influences

Max. Total error : ± 1 %
Temperature influence : -0,015 % / °C
Supply voltage influence : 0,025 % / V

Setting range

Full deflection : 60...105 %
Zero point adjustment : 0...25 %

ZS-Serie

Differential pressure sensor for low pressure

Compact and robust differential pressure transmitter for measurement on air and other non-aggressive media

Properties

Pressure type : Differenzdruck
Housing : Aluminium
medium : Luft und nicht aggressive Gase

Measurement parameters

response time : < 2,5 s
Hysteresis : 0,1 %
Overload capacity : 4* fach bis 500 mbar, darüber 2* fach
Signal output selection : 0...10 V | 4...20 mA, 2-Leiter

Operating conditions

Operating voltage : 24 VDC/AC ±10 % (0...10 V) | 15...30 VDC (4...20 mA)
Operating temperature : -20...+50 °C

Connections

Electrical connection : Schraubklemme im Gehäuse
Process connection : Schlauchanschluss 4 mm oder 6 mm
Cable gland : PG 7

ZDT-Serie

Differential pressure transmitter for high or low pressure applications

Versatile and reliable differential pressure transmitter for measuring air, non-aggressive media as well as liquids and oils.

Properties

Pressure type : Differenzdruck
Housing : Kunststoff
LCD display : optional
Signal output : 0…10 V | 4…20 mA

Measurement parameters

Total error : ± 2,5 % FS (typ. ± 0,5 %)
Linearity error : ± 1 % FS

Operating conditions

Operating temperature : 0...+50 °C
Storage temperature : -20°C...+120°C

ER-107

Electrode Relays with general approval for constructions Z-65.13-405, Z-65.40-191

Electrode relays for conductive level detection with approved design as part of an overfill cut-out device (Z-65.13-405) / leakage protection (Z-65.40-191)

Properties

details : folgen

T203.F

Overfill protection for containers

Properties

Protection class : IP 65 Dose
Sliding tube length : max. 6000 mm
Operating temperature : max. 135 °C
Operating pressure : max. 20 bar
F-Contact : 1/12 kΩ
Switching current : 1A, 2A
Switching voltage : 230 V AC

Float

quantity : max. 6
Type 05 : Oval Edelstahl 76 mm Ø | Dichte 0,81 g/cm³
Type 06 : Oval Edelstahl 90 mm Ø | Dichte 0,67 g/cm³
Minimum contact distance : Typ 05: 110 mm | Typ 06: 135 mm

Switching contacts and switching capacity

Changeover contact : max. 5x | 60 W/VA
normally open : max. 6x | 100 W/VA
Normally closed contact : max. 4x | 60 W/VA

NSP-X-E

Vibrating Limit Switch

The vibrating limit switch is a level limit switch for all kinds of fluids and is used in tanks, containers and pipelines.

Properties

Protection class EN60529 : IP 65/IP 67
Operating pressure : ≤ 40 bar
media density : ρ ≥ 0,7 g/cm³
Viscosity : max. 10000 mm²s
Rated current : < 15 mA
Protection class : III
Output : PNP
power : kurzschlussfest, überlastsicher
Display : LED (grün, rot)
Switching delay (cover) : ca. 0,5 s
Switching delay (release) : ca. 1 s

NSP-1-E

connection thread : G 1”
Operating temperature : –40...+150 °C
Storage temperature : –40...+85 °C
nominal voltage : 10...55 V DC (verpolsicher)
Current output : ≤ 350 mA

NSP-2-E

connection thread : G ½”
Operating temperature : –40...+100 °C
Storage temperature : –20...+70 °C
nominal voltage : 10...35 V DC (verpolsicher)
Current output : ≤ 250 mA

T200

Immersible Magnetic Probe made of PVC, PE, PPH, PTFE or stainless steel (1.4571)

Magnetic immersion probes for use with highly aggressive liquid media for detecting level limits in containers

Properties

connection : Polyesterdose | Aluminiumdose
Protection class EN60529 : IP 65 Anschlussdose
Connector plug : 3- und 6-fach
connection thread : G 1/8" | G 3/8" | G 1/4" | G 1/2" | G 1" | G1 1/4" | G1 1/2" | G2" | G3"
connection cable : LiYY max. 80 °C | PTFE-Litze, 0,24 mm² | Silikon max. 150 °C
Sliding tube length : max. 1000 mm (Rohr Ø 8 mm) | 6000 mm
Operating pressure : max. 20 bar
Viscosity : < 100 cp
Protection class EN60529 : IP 68 Führungsrohr
Switching voltage : max. 250 V
Switching hysteresis : ca. 2...5 mm
Holding range : ca. 12 mm
Contact function : monostabil | bistabil