Home
Cart

Cart

product added to request

Get an offer

Full name*

E-Mail*

telephone*

Company*

street*

place*

zip code*

country*

additional information

I agree that my details and data are collected and stored electronically in order to answer my enquiry.

Your cart

10 article(s) in your cart
pos.	image	product	Configure	Actions
1		T-200.L
2		T200 Ex
3		T201 PTFE
4		TK-304
5		CS-11
6		T200.F-24V
7		QFS-1X
8		NP-25X
9		SG2420
10		ZDT-Serie

TK-304 configure

1 Gewinde

2 Schwimmerausführung

3 Anschluss

4 Rohrlänge

5 Auflösung

6 Zubehör

Amount

additional infomation

T200.F-24V configure

1 Führungsrohr

2 Sicherheitsfunktion

3 Rohrmaterial

4 Anschlussgewinde

5 Ausführung

6 Schwimmermaterial

7 Anschluss-Elektronikteil

Amount

additional infomation

QFS-1X configure

1 Schwimmertyp

2 Kontakt

3 Schwimmermaterial

4 Kabelmaterial

5 TPK

6 Kabellänge

7 Ex

Amount

additional infomation

NP-25X configure

1 Staurohrmaterial

2 Anschlussgewinde

3 Druckschaltermembran

4 Kontakt

5 Staurohrlänge

Amount

additional infomation

T-200.L

Leakage probes with general building authority approval

The leakage probes T-200.L are approved by the "DIBt" on the basis of the "WasBauPVO" for the detection of leaked liquids hazardous to water.

T200 Ex

Magnetic immersion probes with TÜV 02 ATEX 1795X approval for Ex zone 0

Magnetic immersion probes for detecting fill level limit values in containers for liquid media, where an explosive atmosphere of zone 0 (category 1) is present in the gas space above the liquid and zone 1 (category 2) outside the container in the area of the junction box

Properties

connection : Polyesterdose | Aluminiumdose
Protection class EN60529 : IP 65 Anschlussdose
Connector plug : 3- und 6-fach
connection thread : G 1/8" | G 3/8" | G 1/4" | G 1/2" | G 1" | G1 1/4" | G1 1/2" | G2" | G3"
connection cable : LiYY max. 80 °C | PTFE-Litze, 0,24 mm² | Silikon max. 150 °C
Sliding tube length : max. 1000 mm (Rohr Ø 8 mm) | 6000 mm
Operating pressure : max. 20 bar
Viscosity : < 100 cp
Protection class EN60529 : IP 68 Führungsrohr
Switching voltage : max. 250 V
Switching hysteresis : ca. 2...5 mm
Holding range : ca. 12 mm
Contact function : monostabil | bistabil

Operating temperature

ltdata. : max. +60...+150 °C
ltdata. : min. –20... –10 °C
ltdata. : höhere oder niedrigere Temperaturen auf Anfrage

Switching capacity

Changeover contact : 60 W/VA
normally open : 100 W/VA
Normally closed contact : 60 W/VA

Switching current

Changeover contact : max. 1 A
NO/NC contact : max. 2 A

Contacts

Changeover contact : 8
normally open : 10
Normally closed contact : 7

T201 PTFE

Immersible Magnetic Probe made of PTFE

Magnetic immersion probes for use with highly aggressive liquid media for detecting level limits in containers

Properties

connection : Polyesterdose | Aluminiumdose
Protection class EN60529 : IP 65 Anschlussdose
Connector plug : 3- und 6-fach
connection thread : G 1/8" | G 3/8" | G 1/4" | G 1/2" | G 1" | G1 1/4" | G1 1/2" | G2" | G3"
connection cable : LiYY max. 80 °C | PTFE-Litze, 0,24 mm² | Silikon max. 150 °C
Sliding tube length : max. 1000 mm (Rohr Ø 8 mm) | 6000 mm
Operating pressure : max. 20 bar
Viscosity : < 100 cp
Protection class EN60529 : IP 68 Führungsrohr
Switching voltage : max. 250 V
Switching hysteresis : ca. 2...5 mm
Holding range : ca. 12 mm
Contact function : monostabil | bistabil

Operating temperature

ltdata. : max. +60...+150 °C
ltdata. : min. –20... –10 °C
ltdata. : höhere oder niedrigere Temperaturen auf Anfrage

Switching capacity

Changeover contact : 60 W/VA
normally open : 100 W/VA
Normally closed contact : 60 W/VA

Switching current

Changeover contact : max. 1 A
NO/NC contact : max. 2 A

Contacts

Changeover contact : 8
normally open : 10
Normally closed contact : 7

TK-304

Level transmitter for Ex-Zone 0 (Cat.1)

T30... continuous magnetic immersible probes are used for quasi-acquisition of the filling level in containers with liquid media.

Technical Data

connection : Dose
Protection class Socket : IP 65
Float type : 03, 04, 09
Sliding tube length : max. 6000 mm
Operating temperature : max. 135 °C
Operating pressure : max. 20 bar (Kugel) max. 15 bar (Zylinder)
Resolution : 7,5 mm | 10 mm
Accessories : R/I-Wandler TK-101

MaterialDensity

Type 03 : 0,75 g/cm³
Type 04 : 0,65 g/cm³
Type 09 : 0,76 g/cm³

CS-11

CO2 Sensor with digital Interface

Digital CO2 sensor CS-11 for measuring carbon dioxide concentration in mobile applications.

Properties CS-11

Measured variable: : CO2
Measuring range: : 0…5.000 ppm
Measuring principle: : optisch, NDIR
Housing : Kunststoff
measuring grid : 2 sec.
Accuracy : ± 50 ppm
Protocol : I²C-Bus
Operating conditions Temperature : -0°C … 50°C
Operating conditions Humidity : 0…85 % rH
Storage conditions Temperature : -30°C … 70 °C
Storage conditions Humidity : 0…85 % rH

Properties MV-CAN

Housing : Plastik
Mounting : Hutschienenmodul für Einbau in Schaltschrank
Operating voltage : 10…48 V
measuring grid : 2 sec.
CAN protocol : CANopen 2.0 A nach CiA DS 404
Physical Layer : nach ISO 11898
Option : Bereitstellung des EDS-Files
Operating temperature : -40°C … +80°C
Storage temperature : -40°C … +120 °C

T200.F-24V

Overfill protection with 24V direct connection

Level sensors type T-20_.F... are approved by the DIBt (German Institute for Structural Engineering) as liquid level limit switches for the overcharge protection of containers for storing water-dangerous liquids.

Connection

ltdata.Polyesterdose : PO/ET-520
ltdata.Polyethylenanschlusskopf : PE/ET-521

Properties

Protection class EN60529 : IP 65
connection thread : G 1", G 1¼", G 1½", G2", G3”
Union nut : G 2¾", S 100x8
Guide tube length : max. 6 m
Operating temperature : max. 80 °C
Operating pressure : atmosphärisch
media density : ρ ≥ 0,6 g/cm³ (je nach Schwimmertyp)
Switching hysteresis : typ. 2 mm
Switching point tolerance : max. 2 mm

Power supply

nominal voltage : 24 V DC (24…300V DC)
Power consumption : ≤ 1 W

Output

Output contact : 1 potentialfreier Wechselkontakt
Switching voltage : max. 250 V AC / 30 V DC
Switching current : max. 3 A AC / 3 A DC
Switching capacity : max. 750 VA / 90 W

Optocoupler

Switching voltage : max. 30 V
Switching current : max. 100 mA
displays : Betriebs-LED grün, Funktions-LED rot
Switching delay : ca. 0,5 s Anzug/Abfall

QFS-1X

Float switch with reed switch (mercury-free)

Inside the float, one or two reed contacts with a movable permanent magnet are inserted as a switching element.

Properties

Protection class EN60529 : IP 68
Cable entry : PVC , PTFE
Conductor cross-section : 3 x 0,75 mm², PUR 3x0,5mm²
Switching system : Reed-Schalter
Contact : Wechsler, NO, NC (QFS-11 nur NO oder NC)
Switching voltage : 4...250 V AC/DC
Switching current : 1 mA ...1 A
Switching capacity : max. 1A, 60 VA/60 W
Switching hysteresis : ca. 100 mm
Switching angle : ca. + 20° / – 20°

Float

Material Float : PE (Polyethylen)
ltdata. :
ltdata. :
ltdata. :

Operating temperature

TPK(V), AEM : max. + 60 °C
PUR : max. + 70 °C
Silicone,Tefloncable with PE float : max. + 80 °C

Operating pressure

Cylinder : max. 1 bar
Sphere : max. 2 bar

NP-25X

Pneumatic level switch

Reliable & simple probe for sensing aggressive, sticky or heavily contaminated liquids, especially suitable as overflow protection.

Properties NP-250 | NP-252

Connection head : PA
Protection class EN60529 Connection head : IP 54
connection thread : ab G½”
Container connection flange : ab DN 25
Pitot tube material : PVC
Material Screw connection : PVC
Material flange : PVC
Hose Ø : 16 mm / 25 mm
Operating temperature : max. +60 °C
medium temperatur : max. +60 °C
Contact : Wechsler
Switching voltage silver : 250 V AC
Switching voltage gold : 24 V AC
Switching current silver : 6 A
Switching current gold : 100 mA

Properties NP-251 | NP-253

Connection head : PS
Protection class EN60529 Connection head : IP 54
connection thread : ab G½”
Container connection flange : ab DN 25
Pitot tube material : 1.4571
Material Screw connection : 1.4571
Material flange : 1.4571
Hose Ø : 15 mm / 28 mm
Operating temperature : max. +60 °C
medium temperatur : max. +90 °C
Contact : Wechsler
Switching voltage silver : 250 VAC
Switching voltage gold : 24 V AC
Switching current silver : 6 A
Switching current gold : 100 mA

SG2420

Supply unit SG2420 for flow sensor

The DSM-2420 sensor can only be operated in hazardous areas with the associated SG2420 power supply unit or appropriately designed, approved Zener barriers.

Properties